Not yet. I am deciding on what way to make it hold. The only reason the sticy tape doesn't fit is because the sixe of the handle part on the stock cap is larger than the inlet on the TRD
gas cap for it to go into, so the sticky things don't touch the stock cap. So I am still debating on what to do. These are some ways I might do it:
1. Take the two pieces of sticky tape and place them in the inlet part so it sticks to the handle part of the cap.
2. Drill two holes in the cap and into the stock one. (still a little skeptical about doing that)
3. Super glue it inlet part onto the stock cap.
4. Any other smart ideas???
Each idea is good. The drilling I don't know about cause I am afraid the plastic will crack. The glue is good and so is replacing the sticky things. So I need some advice from you people readling this on what is the best way---