Previous Thread
Next Thread
New Reply
Print Thread
Joined: Jun 2015
Posts: 1
New Member
ukcelica Jun 1, 11:46am - #450626 
New Member

Joined: Jun 2015
Posts: 1
Help with a drivers seat

I am in the UK

I recently purchased a 2001, Celica 140bhp

Couple of minor issues with the car, one was a slightly worn side bolster on the drivers seat and the other a worn gear knob

Gear knob was an easy fix

Seat is cloth trim, with red side bolsters

At first I had the idea of buying another seat, passenger or drivers side and swap over the seat back fabric, however, it looked too difficult for me

So, I purchased a replacement drivers seat, colour matched, which arrived today

I cleaned up the seat when it arrived and then followed the how to guide on here on how to remove the seat

All went well, up until the point I got into the car to turn it around, I then noticed the seat had no seat belt anchor point !

I cannot see any easy way to remove the anchor point from my old seat to the new one........

I am now stuck, so any help would really be appreciated

Joined: Dec 2015
Posts: 44
Celipra Dec 21, 12:07pm - #450886 

2001 Toyota Celica GT

Joined: Dec 2015
Posts: 44
west virginia
In my car (01 celi gt) the anchor point for the belt is on the floor board near the seat.
Join the conversation - Register now or Sign in to add your comment

Moderated by  isaac 

Customize Your Toyota CelicaPrivacy Policy · About · Contact is an independent Toyota Celica enthusiast website. is not sponsored by or affiliated with Toyota Motor Sales, USA, Inc. in any way. The Toyota and Celica names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.
©, 2001-2017