All,
I was reading the TSB for lift bolts problem. In page 15, step 23, it reads as followed,
Why would the instruction ask to remove the old packing material (FIPG) and never mention about reapplying the new one? In step B, I am assuming the "seal packing" is different then FIPG, since it is listed as different part at the first page.
I know everyone say I should be able to pop the valve cover off and on with out worrying about this FIPG, etc... but I just want to make sure I am doing this correctly.
By the way, any one got a picture of FIPG, valve cover gasket and the bottom view of the valve cover?
Thanks
ASM