Hello all, I recently bought a 12" 4 ohm Diamond M6 subwoofer (Dual Voice Coil). I have a PPI A600.2 amplifier, and know that it can handle 150x2 watts @ 4 ohms, 300x2 @ 2 ohms, and 600x1 @ 4 ohms bridged. Now, I want to bridge my amplifier so that i can get the 600 watts, however, I don't know how I should do this because I know that it is impossible to wire a 4 ohm DVC sub with an impedance of 4 ohms. I know how to wire the sub so that it will have an overall impedance of 2 ohms, but am not sure if my amp could handle it. If someone will please advise me on what I should do it would be greatly appreciated.