Celica Forums General Discussion Exterior Installing H7 xenon headlights

Hey I was wondering if anyone could tell me the steps for the easiest way to replace the headlight with a new h7 xenon one.

thanks for any help you can give!

hey man welcome...the easiest way is to follow the instructions in the manual...
it's simple dude...

from page 210 of the owners manual...

...

to replace the headlights (low beams)...

remove the clips from your engine plastics.
remove the engine plastics - in doing so, also remove the washer hose from the notch on the cover

unplug the headlight electric connector (if the connector is tight, wiggle it)
remove the rubber cover

release the bulb retaining spring and remove the bulb along with the socket. install new bulb into the socket and return the bulb retaining spring to its original position.
(to install a bulb, align the tabs of the bulb with the cutout of the mounting hole)

install the rubber cover with the "TOP" mark upward, and snuggle on the boss. Insert the electrical connector.
(make sure the rubber cover fits snugly on the connector and the headlight body.

Aiming is not necessary after replacing the bulb. When you believe aiming adjustment is necessary, contact your Toyota dealer

last step - re-install the engine plastics
(always notch the washer hose before fastening it when installing the engine plastics. This prevents washer hose damage.)

don't touch the bulbs either!

dont worry had same problem just look in your owners manual

the bulbs will blow if you touch em