ok my stock bulbs have 2 prongs but they are in a "y" shape instead of one on each side...i shaved one nob off like you suggested but when i put the bulb in..it fell into my headlamp assmebly..it wont lock in and now i have a turn signal bulb rollin around in there..any suggestions??
I have had this same problem. If you go to a hardware store, you can buy a type of snake like tool that has a concealable prongs that will open up and grab pretty much anything. Or you could try and use a magnetic pen. Ask someone at a hardware store.
In case you didn't notice its good to be a Florida Gator. Noles Suck.
My dad had the tool so I tried it..but I can't get the end of the tool with the grabber over to the bulb..it's in the corner and the way everything is angled its very hard to get anything over there..Maybe I just need to try some more..would it be easier to take off the headlight? I scratched the inside a little bit using the tool
CelicaHobby.com is an independent Toyota Celica enthusiast website. CelicaHobby.com is not sponsored by or affiliated with Toyota Motor Sales, USA, Inc. in any way. The Toyota and Celica names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.