Celica Forums General Discussion Exterior Carbon Fiber Air Splitter ?

Well im prob going to purchase the vis air splitter soon. But neways i wanted to know if it does any damage to your Fiberglass by having the rods hold up the weight of the carbon fiber?? does anyone know i have a vs front and i dont want to drill holes and have the Carbon Fiber splitter messing up my bumper ..if its going to damage it in the long run i rather not get it... Also does anyone know how to install this step by step? Thanks

same situation here

it isn't going to sit well on the VS Front due to the curvature of the bumper..

Carbon Fiber is light anyway...it wouldn't do anything.

well im getting the rods so its not going to be drilled from underneth the bumper but rather hanging off of it like the apr splitter... but it will have a part on the bumper where it wont lay flat since its curvature as youve stated above

well no..you drill underneath AND use the rods..
you drill to keep the bottom of the splitter on..can be anywhere on the bumper, mainly towards the end where the Carbon Fiber ends..
then the rods hold the front.

oo thanks i didnt even kno you had to drill underneath i thought that was when you didnt use the rods

yep

tony was it hard to install ?

did you have to take off your front bumper?


EDIT: ok im guessing you def needed to take off your front bumper in order to put that many screws into your front bumper

If you're not cutting it, then it is really easy. You do need to get the bumper off to measure and drill the holes.