Previous Thread
Next Thread
New Reply
Print Thread
Joined: Jan 2004
Posts: 56
Celicalicious
Member
Celicalicious
2000 Red Toyota Celica GT
Member
2000 Toyota Celica GT

Joined: Jan 2004
Posts: 56
Cleveland, OH
Apr 21, 5:05pm - #161331 
Replacing Door Speakers: Hard?

I was wondering who here has replaced their door speakers? And if so if anybody used an amplifier with them? I will be recieving an Infinity Reference Component System and and amp to power them on Friday and am trying to figure out how difficult this will be to install. I read through the install on it, but I do not believe they used an amp with that set up so does anybody know how hard it is to run new speaker wire into the doors? Any hints or advice on the entire project would be most appreciated. Thank you. wave

Joined: Apr 2004
Posts: 97
2K4Celica
Member
2K4Celica
2004 Silver Toyota Celica GT
Member
2004 Toyota Celica GT

Joined: Apr 2004
Posts: 97
Atlanta, GA
Apr 21, 5:12pm - #161332 
Tons of people here have done it. I've done what you're doing except I used the stock wiring in place in the doors instead of running new wire. Chalk it up to my laziness... big enough damn project as it was... sheesh


~ 2004 Silver GT
Joined: Sep 2003
Posts: 286
Psquared
Member
Psquared
2001 Black Toyota Celica GT
Member
2001 Toyota Celica GT

Joined: Sep 2003
Posts: 286
Houston, TX.
Apr 21, 5:14pm - #161333 
Well, you have 2 options to replace the mid bass speaker. You can try to get the stock speaker out of the plastic housing and mount the infiniti in there (if it fits) or you have to make an MDF panel then mount the infiniti to it. The tweeter is relatively simple. Your best bet for wiring to save you the headache is to run the wires from the amp to the back of the headunit, and just use the factory wiring from there. (splice into the factory wiring)I know it's not 100% the best, but if you can hear the difference (and I doubt anyone can) then I would just do that. Running the wires thru the doors is an nightmare.

Joined: Apr 2003
Posts: 2,451
DiabloGTS
Wheezy Joe
DiabloGTS

Wheezy Joe
2002 Kawasaki Ninja 250

Joined: Apr 2003
Posts: 2,451
Lafayette, LA
Apr 21, 6:16pm - #161334 
Just buy a new mount from crutchfield.com and drill the rivets out


To have played and laughed with enthusiasm
and sung with exultation
To know even one life has breathed easier
This is to have succeeded.
Joined: Jul 2003
Posts: 12
SILVERCELIGT
Member
SILVERCELIGT
2000 Silver Toyota Celica GT
Member
2000 Toyota Celica GT

Joined: Jul 2003
Posts: 12
Oklahoma
Apr 21, 6:22pm - #161335 
I found it a lot harder then it looked.I attempted to install Infinity Kappa 60.5CS 6-1/2" (Front Speakers)
Infinity Kappa 63.5i 3-way 6.5"(Rear Speakers)powered by a
Rockford Fosgate 801x.After a couple of hours I gave up and took it to circuit city and it took them 8 hours.


[Linked Image]
Joined: Jan 2004
Posts: 56
Celicalicious
Member
Celicalicious
2000 Red Toyota Celica GT
Member
2000 Toyota Celica GT

Joined: Jan 2004
Posts: 56
Cleveland, OH
Apr 21, 7:39pm - #161336 
Originally Posted by SILVERCELIGT
I found it a lot harder then it looked.I attempted to install Infinity Kappa 60.5CS 6-1/2" (Front Speakers)
Infinity Kappa 63.5i 3-way 6.5"(Rear Speakers)powered by a
Rockford Fosgate 801x.After a couple of hours I gave up and took it to circuit city and it took them 8 hours.

8 hours! Oh man this is gonna be fun. rofl

Joined: Apr 2004
Posts: 97
2K4Celica
Member
2K4Celica
2004 Silver Toyota Celica GT
Member
2004 Toyota Celica GT

Joined: Apr 2004
Posts: 97
Atlanta, GA
Apr 22, 2:52pm - #161337 
Why? It never took me more than 20 minutes or so per speaker to drill the rivets out, cut the factory speaker out, snip the plastic braces holding the magnet of the factory speaker in so I had a clean mount, and drill four screws into the factory mount so my new speaker was mounted, and then bolt it back into the door, and connect the wiring. I'd say all together I spent an hour and a half doing all four, it's not hard and it's the first time I've ever done a stereo install, having owned my Celica less than a month.

I have a few pics of my new 6.5"s screwed into the factory mounts and such from the install I did last week.


~ 2004 Silver GT
Joined: May 2015
Posts: 2
Gymnast7
New Member
Gymnast7
New Member

Joined: May 2015
Posts: 2
Canada
May 23, 6:01pm - #450618 
I have a 2000 Toyota celica GTS, I have an after market deck and amp and subwoofer in it. My front speakers are blown, so I removed my door panels to replace the speakers on each side. I don't need the tweeters replaced, they are still good. But I noticed there are 4 wires going to the tweeter and 4 to the speaker (woofer). Are these wired in parallel? Is there a way to leave the tweeter as is and install a component speaker with tweeter instead of mid as 1 unit?

Join the conversation - Register Now or Log In to add your comment


Moderated by  isaac 

Member Spotlight
Paco7997
Paco7997
2004 Toyota Celica GT
Youngsville, LA

Posts: 49
Joined: March 2004
Show All Member Profiles 
Shout Box
Recent Topics
E-brake and seized brake caliper
by osirhc17. 04/27/2017 10:27 AM
TradingGTS for GT what should I know.
by GTS25430. 04/24/2017 5:19 PM
Does 01' corolla struts swap in an 01' celica GT?
by Frostysnowman92. 04/24/2017 1:22 PM
WTB: 00-02 amp bypass harness
by MJ00GTS. 04/18/2017 7:36 PM
Does not seem to be much activity for the 5th gens???
by Coop301. 04/18/2017 7:51 AM
Cold wet weather hesitation
by GTS25430. 04/17/2017 6:15 AM
00-02 premium 8spkr 2din gps solutions?
by MJ00GTS. 04/17/2017 2:24 AM
WTB: valve assy, vacuum switch
by hydraea. 04/15/2017 5:32 PM
Customize Your Toyota Celica Privacy Policy · About · Contact
Privacy Policy · About · Contact
CelicaHobby.com is an independent Toyota Celica enthusiast website. CelicaHobby.com is not sponsored by or affiliated with Toyota Motor Sales, USA, Inc. in any way. The Toyota and Celica names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.
© CelicaHobby.com, 2001-2017
Powered by UBB.threads™ PHP Forum Software 7.6.1
(Snapshot build 20170416)