Previous Thread
Next Thread
New Reply
Print Thread
Joined: Apr 2004
Posts: 479
vondutchguy
Senior Member
vondutchguy Apr 15, 3:00pm - #155329 

Senior Member
2000 Toyota Celica

Joined: Apr 2004
Posts: 479
Philly, PA
engine plastic question

im replacing the bulbs for my low beams. i know i have to remove the engine plastic by removing the clips on it. can you just pop these clips off with a screwdriver, or is there another way? i dont want to snap them or anything.
Joined: Jul 2002
Posts: 10,123
VSGTS14
05 WRB
VSGTS14 Apr 15, 3:01pm - #155330 

05 WRB
2005 Subaru WRX STi

Joined: Jul 2002
Posts: 10,123
Milford, NJ
you just use something with a small tip to push on the little button in the middle of each clip...then you will see how they attach...simple grin

SUBARU TECNICA INTERNATIONAL
Joined: Apr 2003
Posts: 2,451
DiabloGTS
Wheezy Joe
DiabloGTS Apr 15, 3:02pm - #155331 

Wheezy Joe
2002 Kawasaki Ninja 250

Joined: Apr 2003
Posts: 2,451
Lafayette, LA
when you install them again, make sure you push the center piece up before reinserting or you might break them. After you get them back into the hole, push the center piece down to lock them in place.

To have played and laughed with enthusiasm
and sung with exultation
To know even one life has breathed easier
This is to have succeeded.
Joined: Apr 2004
Posts: 479
vondutchguy
Senior Member
vondutchguy Apr 15, 3:04pm - #155332 

Senior Member
2000 Toyota Celica

Joined: Apr 2004
Posts: 479
Philly, PA
thanks guys
Join the conversation - Register now or Sign in to add your comment


Moderated by  isaac 

Customize Your Toyota CelicaPrivacy Policy · About · Contact
CelicaHobby.com is an independent Toyota Celica enthusiast website. CelicaHobby.com is not sponsored by or affiliated with Toyota Motor Sales, USA, Inc. in any way. The Toyota and Celica names and logos are trademarks owned by Toyota Motor Sales, USA, Inc.
© CelicaHobby.com, 2001-2016